Fishing float cutting method

The so-called cut-off refers to the fact that when the water conditions and the climate are extremely suitable, the fish eat well, and in the three-dimensional nest formed by the well-performed bait, the more fish the more it gathers, causing the fish to float from the bottom; For slow-sinking hook bait, quickly step forward to intercept the hook bait in the mouth, this behavior is the fish on the bait hook section. The cut-off action of the fish allows the fisherman to quickly raise the fish in accordance with the signal on the float, which is the fishing section.

The method of fishing section

1, trial range

According to the fish's habits, there are times when the fish layer is unstable and there are mouths in the middle and lower bodies of water. Nests are crowded with fish, drifting like chaos. When the bottom and fishing floats are not satisfactory, it is necessary to consider the fishing trip, which is usually referred to as the interface.

2, line group with the drift and the choice

There is no change in the model of the fishing rod and the line. The length of the strands and the float used have certain requirements:

1 Strand should use long strands. Longer strands can effectively extend the process and time of two swings, and play a significant role in attracting fish.

2 floats should use long-legged short-tailed floats. That is, "the two heads are short in the middle". This kind of drift is characterized by a quick turnaround, a steady and steady slowdown, and a true fish signal.

3, adjust the drift method

There is no difference between the method of fishing float and the bottom of fishing.

4, use of bait formula

1 The bait is lighter than the important one, and the sinking resistance will become larger after entering the water, and the sinking speed will become slower and the fish will have more effect.

2 The state of the bait should not be too sticky, it must have good atomization, and it must have certain hooking properties. It is best to have residual bait after hooking.

5, the fish's judgment

The fishing trip must catch the non-normal movements that occur in the drift, including the following actions: down, up, acceleration, pause, jog, and traverse.

6, fishing section type

The fishing kerfs are divided into fishing off bottom cuts and fishing half water cutoffs.

(1) From the bottom section

Hook bait sinks to 5 to 10 cm near the bottom of the water, but it is still sinking slowly. The fish caught in the bottom of the water pool sucks the hook lures that sink in front of the sink. Fishing from the bottom cut, in addition to fish concentration, strong appetite, but also requires that the food should be very much on the taste of the fish, throwing rakes to be accurate, throwing rakes should be the same frequency. Fishing from the bottom of the cut, fishing friends must use fine long-tailed floats. When this type of float moves up and down in the water, the resistance to water is minimal; it can amplify the signal at any time, and it can reflect the fish's section information more clearly. The response is very sensitive.

(2) Half-water cut

Basically, the hook bait sinks to half full depth from the water level, or two-thirds of the time, the fish intercepts the lures. Fishing half-water cuts, not necessarily with slender floats, choose a fine float to stand up and float faster, the effect will be better.

7, floating action

Whether it is fishing from the bottom or fishing half-cut, it is better to adjust the float or level the water. When the fish sucks and intercepts the lure population, the signal response on the float has the following situations.

(1) Minor down

The lower range of this signal float is small, usually only one-third to one-fifth. The reason is that when the bait bait is in the second hem, the direction in which the bait is used to pull the hook bait is horizontal, so it is difficult for the float to show a noticeable and powerful force.

(2) Accelerate the decline

In the sinking of the lead sinker, the float floats at a constant speed and sinks vertically. The fish grabs the bait halfway, causing the float to sink in the sinking speed. This signal is more obvious.

(3) Short pause

As the float sinks at constant speed, a brief pause suddenly appears. The cause is the hook bait doing the first hem process with the lead sinking. The fish intercepts the hooked bait and holds the sinking lead sinker, causing the floater to lose weight momentarily and stop sinking. However, this brief pause is not easy to see without careful observation.