A video from a frontline reporter at the 2016 CES site in Las Vegas, USA, caught our attention – at the NewPro3D booth, the show showed a 3D printed hollowed-out polyhedron in a few minutes. This process is very similar to the CLIP technology we reported earlier.
In less than 5 minutes, a hollow polyhedron is printed.
NewPro3D gives the principle explanation of its own ILI (Intelligent Liquid Interface) 3D printing technology . Surprisingly, ILI technology and CLIP technology have high similarity in schematic and description. The ILI technique adds a layer of wettable membrane to the bottom of the resin cell to form a dead zone in the upper layer that inhibits the rate of resin cure on the dead zone. That is to say, the ILI technology relies on the dead zone to prevent the hardened resin from sticking to the bottom of the pool, enabling continuous curing printing, which is the feeling we see from the pool. The description of CLIP technology is exactly the same.
ILI technology principle
Dead zone and suppression polymerization are mentioned in the description of ILI technical principle
CLIP technical schematic
wire holder is made of high quality 304 stainless steel, It is easier to clean without rust, safe, healthy and durable, Prevent rust or chemicals from contaminating food and damaging health. Suitable for putting the wine glass holder.
China leading manufacturers and suppliers of Wine glass holder,Goblet Holder, and we are specialize in Wine Rack,Hanging Wine Rack, etc.
Goblet Rack,Stainless Steel Goblet Rack,Wine Glass Holder,Wine Glass Rack
Shenzhen Lanejoy Technology Co.,LTD , https://www.szsmallcompressionspring.com