Today's CTP machine common problems and treatment methods are as follows: speed of the plate machine: in the case of CTP energy standards, the version has a blue bottom. Adjustable wiper machine speed; Rushing machine barbing pressure This method is rarely used, in the case that the above 1-2 are invalid, the pressure of the bar can be adjusted properly, this article will introduce you to the ctp plate machine accessories .
The plate machine uses a low concentration of glue in the gluing process, and oxidation of the non-image part will cause the plate of the plate to become dirty. The solution to this kind of problem is: the plate surface of the plate machine should be fully washed after being dirty. When the plate machine is glued, the glue concentration should be increased, and the glue should be evenly distributed; after the dirty note is used up, it should be tightly closed; Version, the plate length of the plate machine is dried and then printed.
The thermal plate-making machine is equipped with an emergency stop switch on the imported plate feeding table; it is convenient for handling problems under special circumstances and avoiding unnecessary troubles. The washing machine drys the overheating automatic protection device; the liquid level is too low, the automatic replenishing device; the mechanical transmission system's closed protection device; and the safety warning sign of the safety important parts of the plate machine are safely designed.
Use the special cleaning agent for the platen machine, just dilute the concentrate with water, heat it to the developing machine tank and heat it to 30 °C, and start the cycle for 30 minutes to clean the dirt in the tank. Or dilute the concentrate with water, dip with a brush, brush the tank, rubber roller and brush. Please refer to the product's instruction manual for the specific dilution ratio.
Article source address: http://
Ningbo XISXI E-commerce Co., Ltd , https://www.petspetskitty.com