Solid photosensitive resin plate exposure process

The plate making process of the solid photosensitive resin plate is as follows:

Exposure - "Flush -" after the exposure

The following details the various processes:

1. exposure

Remove the protective film of the resin plate and apply some talcum powder to facilitate the absorption of the plate material and prevent the film from sticking to the plate material, and then expose it.

Observe the side of the prepared plate with a magnifying glass and you can see that the photosensitive coating is a trapezoid, and the normal angle a is about 70°. The a angle decreases as the exposure time increases. The exposure time is long and the characters and lines are firm. After washing and drying, the characters are not easy to drop, and they are not easy to bend. However, the printed version is not thorough enough in a small area, which gives the impression that something is not washed clean; The exposure time is short, and the angle a increases. After the washing and drying, the light is cut off and the lines are bent. The heavy words and lines are washed away. If you do not know the correct exposure time, you can use a small piece of media, select a different exposure time for exposure, rinse, dry, watch the publication of the slope, you can determine the correct exposure time. Tianjin Ketai PVA-500 plate exposure time is about 5 ~ 7min.

2. Rinse, dry

When the resin plate is flushed, the flushing time should be shortened as the rinse water temperature increases. However, the water temperature cannot be too high. Generally, the flushing water temperature of domestically produced plates is set at 45°C. The washed plate can be placed directly in the drying room of the plate making machine. The temperature is set at 90°C for 15 to 20 minutes.

3. After exposure

The prepared plate is directly exposed in the exposure chamber of the plate making machine, and the post-exposure time is generally equal to or greater than the first exposure.