Balance handmade

1. First cut the plywood into A, B, C, D.

2. Open at the bottom end of B. The middle opening of C and D.

3. Insert the three thin strips as shown in the figure.

4. Pin A to the upper middle section of B, but be careful not to nail it, so you can move freely.

5. Cut the crescent-shaped target with a plywood and mark it with a scale.

6. Cut a small strip and fix it on A with universal glue, as shown in the figure.

7. Cut two wafers of equal size.

8. Tie four small holes on each side.

9. Cut a small slot on each side of A.

10. Use a thin wire to tie the disc and the balance is made.