After camping in the wild, it is necessary to face a problem to build and store tents. The tents are fast and good. Not only do they have a good night's sleep, they don't have to worry about the wind blowing in the evening. The folding of the tents can not only save a large part of the space inside the climbing bag, but also the correct folding method. To better extend the life of the waterproof coating, I will briefly explain how to build and store tents.
The tent construction first determines the location where the tents are to be erected. According to the order, four people work together and it is easy to set up without spending much time. In order to take into account the situation when the tent is withdrawn, it is convenient to write down the initial collocation.
There are different kinds of tents and there are different ways of making, matching designs and combinations. The combination of small tents, A-shaped tents, and wall-type tents is based on the order of their construction. It is the use of cables to set up tents. The recently developed and improved warhead and hut tents belong to the "combination tent."
In the following, one of the basic types of tents is the wall type tent that has been widely used since ancient times as an example to explain how to set up a tent.
The decision of 1 place chooses a flat land after considering the wind direction and terrain.
2 Inspection of the tent equipment Pour out the contents of the bag and check each part one by one. In order to facilitate the withdrawal of the tent and not to miss something, it should be recorded first.
3 Laying a floor mat After laying the floor mat, fix the four corners with a nail. If there is a lot of moisture, put a mat first and then lay a mat on it.
4 erect the pillars, pull the main rope below the pillars to wear the ground mat at both ends of the hole, at the same time, the upper part of the pillar, piercing the columns of the pillars of the pillars, pull the left and right master ropes to avoid left and right tilt . In this way, the main body of the tent is formed.
5 Adjust the main rope, pull up the corner rope and the waist rope to attach to the main rope. Adjust the shape of the tent and put the two pillars upright on the ground. Secondly, adjusting the corner ropes and waist ropes with the support ropes will make the form of the tents appear.
6 Fix the walls to connect the tent base fabric, floor mats and the lower part of the wall.
The above is the erection sequence of the wall-type tents. The four people can work in groups and divisions. In a state of skill, it can be completed in about 10-15 minutes.
In general, roof covers are added to reduce the effects of wind, rain and cold. In step 4, when inserting the pillars into the holes at both ends of the human ridge, first add the roof cover, and then pull the master rope. After the master rope is fixed by nails, use the vertex of the roof ridge as the apex to form two sides of the equilateral triangle. The length of the bottom edge is drawn to be equal to the length of the pillar. From the top of the roof, the corner rope should extend on the diagonal line, and the waist rope should be in line with the corner rope.
In the past, after the tent was erected, it was possible to dig trenches around it. Now, we must stand in the position of protecting nature. Unless we are in the water, we will no longer dig trenches.
The first step of the storage of the tent: the tents are removed, flattened and put on the ground;
The second step is to fold the bottom half of the book, just like the quilt you folded. After folding, the width is slightly shorter than the storage bag. Why is it shorter than the storage bag? Because there will be errors when the next volume, so you will become longer after the width of the volume is variable, so it is difficult to fit into the storage bag, the general width of the storage bag when the small 5 cm can be smaller.
The third step is to fold the outdoor account into a similar width, and then stack it on the bottom account and put the dike and the tent pole in the same account.
Fourth Cloth: Open the book and slowly roll forward until the tent is completely rolled up. Remember to take it slow so that the gas in the tent can be completely discharged. Finally, you can put it in a storage bag. Why choose to refold with a roll rather than folding it? Because folding can damage the coating very much, it is recommended that you choose to use the roll instead of folding the tent so that the life of the tent will increase. In addition, the folding method of the sleeping bag and the tent are also similar and can be used mutually.
The tent construction first determines the location where the tents are to be erected. According to the order, four people work together and it is easy to set up without spending much time. In order to take into account the situation when the tent is withdrawn, it is convenient to write down the initial collocation.
There are different kinds of tents and there are different ways of making, matching designs and combinations. The combination of small tents, A-shaped tents, and wall-type tents is based on the order of their construction. It is the use of cables to set up tents. The recently developed and improved warhead and hut tents belong to the "combination tent."
In the following, one of the basic types of tents is the wall type tent that has been widely used since ancient times as an example to explain how to set up a tent.
The decision of 1 place chooses a flat land after considering the wind direction and terrain.
2 Inspection of the tent equipment Pour out the contents of the bag and check each part one by one. In order to facilitate the withdrawal of the tent and not to miss something, it should be recorded first.
3 Laying a floor mat After laying the floor mat, fix the four corners with a nail. If there is a lot of moisture, put a mat first and then lay a mat on it.
4 erect the pillars, pull the main rope below the pillars to wear the ground mat at both ends of the hole, at the same time, the upper part of the pillar, piercing the columns of the pillars of the pillars, pull the left and right master ropes to avoid left and right tilt . In this way, the main body of the tent is formed.
5 Adjust the main rope, pull up the corner rope and the waist rope to attach to the main rope. Adjust the shape of the tent and put the two pillars upright on the ground. Secondly, adjusting the corner ropes and waist ropes with the support ropes will make the form of the tents appear.
6 Fix the walls to connect the tent base fabric, floor mats and the lower part of the wall.
The above is the erection sequence of the wall-type tents. The four people can work in groups and divisions. In a state of skill, it can be completed in about 10-15 minutes.
In general, roof covers are added to reduce the effects of wind, rain and cold. In step 4, when inserting the pillars into the holes at both ends of the human ridge, first add the roof cover, and then pull the master rope. After the master rope is fixed by nails, use the vertex of the roof ridge as the apex to form two sides of the equilateral triangle. The length of the bottom edge is drawn to be equal to the length of the pillar. From the top of the roof, the corner rope should extend on the diagonal line, and the waist rope should be in line with the corner rope.
In the past, after the tent was erected, it was possible to dig trenches around it. Now, we must stand in the position of protecting nature. Unless we are in the water, we will no longer dig trenches.
The first step of the storage of the tent: the tents are removed, flattened and put on the ground;
The second step is to fold the bottom half of the book, just like the quilt you folded. After folding, the width is slightly shorter than the storage bag. Why is it shorter than the storage bag? Because there will be errors when the next volume, so you will become longer after the width of the volume is variable, so it is difficult to fit into the storage bag, the general width of the storage bag when the small 5 cm can be smaller.
The third step is to fold the outdoor account into a similar width, and then stack it on the bottom account and put the dike and the tent pole in the same account.
Fourth Cloth: Open the book and slowly roll forward until the tent is completely rolled up. Remember to take it slow so that the gas in the tent can be completely discharged. Finally, you can put it in a storage bag. Why choose to refold with a roll rather than folding it? Because folding can damage the coating very much, it is recommended that you choose to use the roll instead of folding the tent so that the life of the tent will increase. In addition, the folding method of the sleeping bag and the tent are also similar and can be used mutually.
Jinzhou City Hejin Clothing CO.,Ltd , https://www.hejin-cloth.com