With the development of society, there are more and more high-tech nowadays. Ancient humans wash clothes on the banks of small rivers. With the tap water, people can wash at home, then with the development of science and technology, now With the washing machine, from the washing machine that we need to set up before, but now the automatic washing machine, as long as there is water and electricity, the faucet on the washing machine is also a more important part, then how to solve the leaking of the washing machine faucet ? How to install the connected washing machine The faucet will not leak water? There are also precautions when using it.
First, how to solve the leaking of the washing machine faucet?
1. There are many reasons for water leakage. If there is water leakage, then we must first check what is wrong and which parts need to be replaced. The most common one is that the tape above the faucet is broken. If this is the case, then We can use the pipe wrench to remove the faucet and install it on the wrapped water-stop tape;
2. If the case of the tape parts of the faucet is not bad, then we have to consider is the problem faucet outlet, and under normal circumstances is the axis washer inside the faucet is broken, so we can use the wrench to the Remove the faucet gland, use a pair of tweezers to clip the faucet intermediate shaft gasket, and then replace it with a new one;
3. If you don't have the above two conditions, it may be leaking in the gap under the faucet. In this case, loosen the screw to loosen the plug, then remove the gland. Take out the triangular seal and replace it with a new one.
4. The most likely is that the switch of the faucet has a problem, and it may cause the faucet to leak. You can replace it with a new one, or you can re-wrapp the waterproof tape to tighten it.
Second, how to install the faucet connected to the washing machine will not leak
1. First use raw tape to wrap a few turns around the interface between the faucet and the water pipe, and tighten the water outlet tightly. If you are afraid of leaking water, wrap a few turns of raw tape;
2. Then insert the water outlet of the faucet into the water inlet of the washing machine, and then pull down the water outlet, so that you are not afraid of water leakage. Of course, you need to test all the parts without any problems, and will leak water;
3. If the plastic faucet can not be tightened too much, otherwise the faucet will be broken, stainless steel is no problem, the stainless steel faucet is best tightened.
Third, the use of automatic washing machine precautions
1. First, follow the instructions of the washing machine to understand, pay attention to the plug of the power supply and the drain of the washing machine;
2. Pay attention to the water pressure, don't be too strong, pay attention to the water spray; do not wrap too much raw material tape to avoid being weak;
3. Pay attention to the water content inside the washing machine, how much water should be put according to how much clothes, after turning on the power, pay attention to the upper indicator light, and pay attention to whether the washing machine is working properly;
4. That is after the final washing and drying the clothes, dry the washing machine, pay attention to the cut off of the power supply, and the closing of the water pipe to ensure safety.
The above is about the treatment method when the washing machine faucet leaks. I hope that my introduction is helpful to everyone. There are small problems in this area. I don’t have to spend money to find a professional. I can do it myself later, and there is a use of the washing machine. Note, for more information, please continue to pay attention to the decoration home network!
More related wonderful reading:
How to do the washing machine faucet when the washing machine faucet leaks
Washing machine faucet to buy washing machine faucet leaking reason
Pvc Backpack,Pvc Book Bag,Pvc Sling Bag,Clear Pvc Backpack
Ningbo Happiness Stationery Industrial & Trading Co Ltd , https://www.cnhappiness.com